■Features
・High speed printing of roll material
・Alignment with image processing
・Digital control of printing parameter
・Complete printing line with Feeder and winder
・Digital setting of clearance amount
・Traditional stencil frame can be use
・Feeding directing printing length can be change
・Minimum margin of non-printable area
・Hot air, IR, UV dryer selectable
・Machine without image processing unit is available
Large caliber cylinder use to prevent base peeling failure
Reliable MIP image processing alignment system
Digital setting for clearance amount
Squeegee and flood coater pressure can be set digitally or manually
Reliable winding system
Stretch correction parameter can be control by touch panel
■Outline drawing
■Specification
| Max. material width | 600mm | Frame stroke | Numeric input |
|---|---|---|---|
| Min. material width | 330mm | Material feeding amount | Numeric input |
| Material thickness | 50～200μm | Frame micro adjustment | Numeric input |
| Pattern spacing | 10mm | Frame lifting | 400mm |
| Material mounting | Cantilever air shaft | Squeegee angle | 65°～80° |
| Feeding location adjustment | Y direction by EPC automatically | Pressure adjustment | Numeric input+manual |
| Material remaining alarm | Ultrasonic sensor detection | Squeegee, flood coater up down | Servo motor |
| Printing repeatability | ±0.05mm | Alignment | MlP※ |
| Frame size | 950×950mm | Alignment camera | CCD×2units |
| Max. printing area | 550×510(550)mm | Camera movement | Servo motor |
| Min. printing area | 280×300(stroke)mm | Winder mounting | Cantilever air shaft |
| Mark location | Width direction 300～570mm | Winder location adjustment | Y direction by EPC automatically |
| 290mm from feeding side pattern | Electricity | 200V60A | |
| Touch roller | 10mm from material edge | Weight: feeder, printer and winder | 310+2200+880kg |
| Vacuum hole | φ0.5mm | Air source | 0.5MPa,10ℓ/min |
